<strike id="hfssx"><input id="hfssx"></input></strike>

    <strike id="hfssx"></strike>

    <p id="hfssx"><th id="hfssx"></th></p>
      <strike id="hfssx"><input id="hfssx"><form id="hfssx"></form></input></strike>
      <label id="hfssx"></label>
    1. <span id="hfssx"><input id="hfssx"></input></span>

      <span id="hfssx"><u id="hfssx"></u></span>
      <s id="hfssx"><dfn id="hfssx"><option id="hfssx"></option></dfn></s>

      日常玻璃鋼制造工藝中的模具硅膠到底是不是越濃稠越好呢?

      發布時間 : 2019-12-26  瀏覽次數 :


      日常玻璃鋼制造工藝中的模具硅膠到底是不是越濃稠越好呢?


      2-191226103026333.png


      對于模具硅膠的選擇一般都是取決于本來要做的工藝的大小而決定的。


      模具硅膠的選擇

      2-19122610312X32.png


      一般來講如果操作得當,在灌注模具的時候可以選擇硬度參數為20或者40度的硅膠,總的來講


      采用硬度參數為20的硅膠做的特點:做小件工藝品,粘稠度小,流動性能好,容易操作,容易排出泡泡,拉力撕裂強度足,容易灌注。


      采用硬度參數為40的硅膠做的特點:做大件產品,粘稠度大,流動性也好,容易操作,容易排除泡泡,拉力撕裂強度好,容易灌注。


      模具硅膠的結構




      模具硅膠來講一般是分為幾種組合構成的分別有,基膠,交聯劑,催化劑,填料和添加劑等等五個組合。從實際操作來講其實只需要前三者便可以做成模具硅膠但是獲得為了獲得更好的強度,填料一般是必須的,而添加劑是按照現在實際情況而定的。通?;z,交聯劑和填料被制成一個組份,而催化劑作為一個單獨組份。催化劑組分與主膠組份的比一般在1%—3%之間,可通過調整催化劑比例而調整膠聯反應速度。



      国产真实伦实例|在线中文字幕高潮潮喷|日本无卡码高清免费v|国产又爽又粗又硬又适应|亚洲成av人片在线观看www

        <strike id="hfssx"><input id="hfssx"></input></strike>

        <strike id="hfssx"></strike>

        <p id="hfssx"><th id="hfssx"></th></p>
          <strike id="hfssx"><input id="hfssx"><form id="hfssx"></form></input></strike>
          <label id="hfssx"></label>
        1. <span id="hfssx"><input id="hfssx"></input></span>

          <span id="hfssx"><u id="hfssx"></u></span>
          <s id="hfssx"><dfn id="hfssx"><option id="hfssx"></option></dfn></s>